Ford Forums banner

ignition query

1K views 4 replies 0 participants last post by  Austin Shackles 
G
#1 ·
Could a poor earth on the ignition coil condenser cause misfiring under load
?


--
Larry
Series 3 rust and holes
 
G
#2 ·
Bugger it ain't a condenser is it (even if it looks like one) but a
resistor, still have no idea what its for and if a bad erth could have been
causing problems


--
Larry
Series 3 rust and holes
 
G
#3 ·
Larry wrote:
> Bugger it ain't a condenser is it (even if it looks like one) but a
> resistor, still have no idea what its for and if a bad erth could have been
> causing problems
>
>

Its not a ballast resistor is it Larry ?

Steve
 
G
#4 ·
Whatever it is, its the thingy on the positive side of the coil that was not
making a very good erth because the screw holding it and the coil on, will
not tighten up securely. What exactly does it do anyway ?

--
Larry
Series 3 rust and holes




"Steve" <steve@thetaylorfamily.org.uk> wrote in message
news:43b3034e$0$29571$da0feed9@news.zen.co.uk...
> Larry wrote:
> Its not a ballast resistor is it Larry ?
>
> Steve
 
G
#5 ·
On or around Wed, 28 Dec 2005 22:24:11 -0000, "Larry" <NDA@larry-arnold.cwm>
enlightened us thusly:

>Whatever it is, its the thingy on the positive side of the coil that was not
>making a very good erth because the screw holding it and the coil on, will
>not tighten up securely. What exactly does it do anyway ?


if it's from the live side of the coil to earth, then it's an interference
suppressor. It'll be a capacitor in this case. You can safely remove it...
--
Austin Shackles. www.ddol-las.net my opinions are just that
Too Busy: Your mind is like a motorway. Sometimes it can be jammed by
too much traffic. Avoid the jams by never using your mind on a
Bank Holiday weekend.
from the Little Book of Complete B***ocks by Alistair Beaton.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top