Ford Forum Ford Forum

ยป Wheel & Tire Center

» Sponsors
» Sponsors
Go Back   Ford Forums - Mustang Forum, Ford Trucks and Cars
Register Home Forum Active Topics Photo Gallery Mark Forums Read

Please Visit our Site Sponsors

FordForums.com is the premier Ford Forum on the internet. Registered Users do not see the above ads.
View Single Post
Old 09-16-2008, 20:55   #7 (permalink)
timcdo
Registered User
 
Join Date: Sep 2008
Posts: 1
Re: Misfire codes after head gasket job

I have had the same issue, and im at wits end. I have replaced, the fuel pump, filter, plugs, wire, coil, injector, cam shaft position sensor, and a complete head gasket job, not to mention a new alt, and battery. I am still getting the misfire on cyl 1 error code. I have honestly sunk enough money into this car that I get sick just looking at it. It is my daily runner, and I have to drive it as is. It still has a ton of get up and go, and barrels down the highway with no issues, but still has the misfire at low rpms and idle. Occasionally the CEL will flash and the engine barely has enough umph to get going. I did notice when I replaced the #1 injector the car ran great for about 20 miles. Purred like a kitten, and lots of power. However it shortly went back to the same problem. Please help. 2001 Taurus V6 3.0 VIN U

Thanks in advance.
timcdo is offline   Reply With Quote
 
Powered by vBadvanced CMPS v3.1.0

All times are GMT -7. The time now is 14:28.

Powered by vBulletin® Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.