The fuel pump in my EA shat itself and I'm trying to put in a newie between doing other things.
But I need to know how to get the plastic ring off (retaining nut) around the sender assembly (bit on top of tank but under the cover held down by screws).
Yes mate according to the godbook it unscrews, you need a special tool as usual, but i can see any harm in using a pair of multigrips, it also says NOT to unclip the loom @ the retaining ring but 100mm further back?. Any more Qs
You're better off getting the tool, or finding someone that does. Those lock rings are a pain in the arse!!! Without the right it's hard to get them up tight enough to seal properly.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ford Forums
1.4M posts
115.6K members
Since 1999
Ford Forum is a community to discuss all things Ford. Check out our discussions on the Ford Escape, Mustang, Edge, F-150, Raptor, Explorer, Focus, Fusion, Fiesta and more!