JakoMan0960

I have an 87 GM and i need to grease the Ujoint and it dosnt have any grease fittings. How else can i do it.
Thanks Jake

thefonz

The only other way is to remove the bearing caps, and put some bearing grease in it with your fingers. I guess you could also remove everything, drill and tap it for a fitting, clean and reinstall and lube as usual. But it would be better to just replace them.

dryelf327

x2 on just replacing them.

__________________
My Fords:
'98 Crown Vic LX
-167k miles and counting. Still used as daily driver.

'99 Crown Vic Police Interceptor
-Completed full PI swap
-Marauder Airbox & 80mm MAF
-'04 CVPI Ziptube
-ADTR ported plenum
-Steeda Intake Spacer
-BOC tune
-J-Mod tranny

Nathan in MN

Yep, buy universal joints with grease fittings in 'em. Usually you'll find the cheapie chassis parts have grease fittings, as do the high end ones (Moog, etc.). Ones in the middle are usually "greased for life".

__________________

1989 Ford Crown Victoria Police Interceptor
2bbl Carbureted 351W V8, ported and polished E7TE heads, Edelbrock cam
AOD Transmission with B&M Shift Kit
3.55:1 Positraction Rear Axle
Visit My Car Domain Account Here Updated 1/27/07!