Re: LCM help
thats hard for me to see, but if you can find and trace where that component goes to relating to the black jack, in other words see what the harness wires say, do they say +12 volt, gnd, etc. If you can find a negative and positive on that harness that goes to the black connector, then you would most likely say its a diode if one of them (+ or 1 volts) goes to the burn part. You can also just remove that diode or jumper it and see if things work again. Do note that you must make sure you dont get that short again, cause it will burn the board without a diode. the diode was made to burn up to protect the rest of the components. I dont have the old one anymore, but I will look for it. If I find it I will certainly make a post again on it.