work has comenced - Ford Forums - Mustang Forum, Ford Trucks, Ford Focus and Ford Cars

460cixy · 07-08-2003, 06:32

work has finaly comenced on project hrd.yka460 super ute haveing owned this xy for a year now it has finaly found home in my shed :) i started attacking it with a wire brush on a grinder today and the worst i have found so far is a little putty over some old lead filling so nothing but top notch bodywork has been found so far will update tomomrow with some pics after work if its not too dark. less some one here can get me new fluro,s and starters for my lights cheap

Fordy · 07-08-2003, 07:19

good to hear another classic rebuild in the process, look forward to seeing some pics.

EFJase · 07-08-2003, 07:30

Good to hear, hope it goes well

Fordy, whos that in your avatar?

Jase

XF Falcon · 07-08-2003, 08:34

That would be Veronica Zemanova there EFJase.

One of the perks of running an ex pr0n site :)

460cixy · 07-10-2003, 02:52

this work took 10 hours and smoked out one ryobi angle grinder

Fordy · 07-10-2003, 03:03

Looks like you got alot of work ahead of you there 460cixy.

YuGoStaR · 07-10-2003, 04:26

One grinder down, 50 more to go....hehe
Keep on chuggin there mate.

460cixy · 07-10-2003, 04:55

i am useing a makita grinder now is older than the ryobi but much better it dosent seent to vibrate as much but it did a bearing the other day but i found one out of an old husky wipper snipper motor fitted no worrys but its makeing noise again it will go again soon im sure i should get pics of the dead grinders

Fordy · 07-10-2003, 08:35

Hehe i went thru a couple of grinders one was a ryobi and i even stuffed a DEWALT up.

CATman · 07-11-2003, 00:57

It would be cheaper to by a 4lt of paint stripper, scratch the serface up with a little bit of 40 grit sand paper, and put that on. :) and a lot quicker and easier. :)