i have an 88 Fullsize Bronco w/ a 351. I went to start it and it was real sluggish but finally started. It sounded like it was trying to turn over then after 4 or 5 seconds it would start. Before last week it started up in a snap. I replaced the starter solenoid. I went to crank it and it did the same thing then when i went to shut it off it cut off but the motor was still trying to turn over. I had to take the ground off the battery to get it to stop. I need to know how to get it to quit doin that and how to get it to start right. Any help would greatly be appreciated.
i have an 88 Fullsize Bronco w/ a 351. I went to start it and it was real sluggish but finally started. It sounded like it was trying to turn over then after 4 or 5 seconds it would start. Before last week it started up in a snap. I replaced the starter solenoid. I went to crank it and it did the same thing then when i went to shut it off it cut off but the motor was still trying to turn over. I had to take the ground off the battery to get it to stop. I need to know how to get it to quit doin that and how to get it to start right. Any help would greatly be appreciated.
Hello All,
I'm new here. I have an 1985 ford Bronco 2. I'm having problems with the starter. I think that its missing 1 screw, so the started keeps moving. So when i try to start it it just spins. Does anybody have Started Diagrams or how the started should be installed properly ? Please Help, I'm trying to get this Baby started.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ford Forums
1.4M posts
115.4K members
Since 1999
Ford Forum is a community to discuss all things Ford. Check out our discussions on the Ford Escape, Mustang, Edge, F-150, Raptor, Explorer, Focus, Fusion, Fiesta and more!