arkusvt

just bought a pair of front seats from an '05, to replace the ones in my '66. driver's seat is power and i need to know how to wire it. there is a yellow plug with 2 red wires and a grey plug with one large green, one large black, one small black with a blue tracer, one small brown with a blue tracer and one small green with no tracer. would sure appreciate any help i could get on this. an electrician i am not! thanks

Bert

The large green and large black are all you need. Green is power and black is ground. The others are for seat belt light and seatbelt tensioner etc..

__________________
Bert

arkusvt

thank you VERY much for the reply.:

arkusvt

bert, hooked up the green and black as you said and the switch that actuates the up/down, back/forth works perfectly. there is a smaller "rocker" type switch to the front and higher up on top of the plastic that still does not do anything. i thought it might be a lumbar switch, but i really don't know. any ideas on what it does and how to make it work? thanks

Bert

As far as all of my diagrams, which I only have up to 2001, the same green wire that you hooked up is supposed to go to the lumbar too. I'll see what I can come up with.

__________________
Bert

Bert

The same wires are connected to the lumbar. I looked up to 2007. Did you listen closely? They are pretty quiet.

__________________
Bert

arkusvt

bert, they are VERY, VERY quiet. it works just fine. thanks again.

Bert

Thanks for the update. Glad all is well.

__________________
Bert