schwing

I have no idea how to remove the Hydraulic Clutch Line from the slave cylinder on the transmission. There is no quick-disconnect. And there is no white piece that I have previously read about when I searched forums. I have tried slipping a metal clamp over the hose and sliding it down into the fitting but nothing happened. Can someone please help me?

Bert

It may be missing, so then you need to get a small screw driver and working from one side to the next, push that plastic clip into the cylinder housing until you can no longer see it. Then pull on the line.

__________________
Bert

Bert

Here's some more info. How to Remove a Clutch Line - The Ranger Station Forums

__________________
Bert

schwing

I just out to the truck and I put it on jack stands. I wasn't sure whether to do it from underneath or above the truck. I tried pushing the base of the line. I didn't see the "plastic clip" that I was supposed to be pushing in. What kind of screw driver should I use?

schwing

I just wanted to reiterate that this line is getting replaced with a new line. Would I be able to cut the line off of the slave cylinder some how?

Bert

You'd still have to remove it from the slave cylinder. Can you put the plastic piece on it from the new line to remove it?

__________________
Bert

schwing

Don't have the new line yet. Do you have a picture of what this white thing is supposed to look like. Or I would probably just know when I get the new line?

Bert

Here's the best picture I could find. Ford F-150 Clutch Hydraulic Line

__________________
Bert

schwing

Well I suppose that I'm just going to order a new line the of the internet and hope that it comes with this white clip, if it doesn't I'm going to be furious.

Bert

I thought you were replacing it anyway as per your previos post?

__________________
Bert