JP67

i have a clevo which has only done 1500 miles (since rebuilt) and havent started it for about 8 mnths, will it be ok if i just disconnect the coil lead till i get oil pressure, also i have electric fuel pumps?i do little driving as im busy

Tote

I'd prime the oil system by removing the dissy and spinning the oil pump drive then wind it over with the spark plugs removed by hand so you dont snap any rings. Then you should be able to start it.
Regards,
tote

ebxr8240

Or pull lead off coil and crank over on battery...I have one in back shed been sitting there since 1985!!!!

__________________
Don't be afraid to try something new. Remember, amateurs built the Ark...Professionals built the Titanic!
.
Tuned & maintained by "Peppertree Perfmormance". Dart block, Scat 4340 steel crank, Custom C.P pistons.Oliver rods.. Mal Wood twin plate clutch.. Twin SC61/2's,482 rwkw/ 645 rwhp..
Passengers, myocardial infarction material..
R.I.P Possum...

rod051

you may also want to pull the carby off and give it a good clean and replace the gaskets.

JP67

thank guys cheers jp67