TTNOS8

Hey All,

Just wondering where in Melbourne is the best place to get a Cleveland Electronic Distributor re-graphed for a reasonable dollar.

Have contacted a place on the eastern side and now lost their name/address.

Around $120 about the going rate?

Thanks :)
TTNOS8

XWGT

I used Ice Ignitions in Moorabin/Chelthenham?
Brand new dizzy, graphing and entire system about $600
I would recommend them again

__________________
Chevs may go, but theres nothing like a HO!
Proud LSUG Member, and 9" Nodular Iron driveline test pilot.
Member FGTCoA
www.falcongtclub.org

Fat F100

I used IC&E aswell. Brand new Bosch coil, Distributor & lead set for $750 a couple of years ago. I asked them to regraph the module & they would do it for about $120, so that sounds about right.

ESP

Try Ignition Torque

Fcty 8/ 78 Bayfield Rd Bayswater 3153 (03) 9720 6308

@ 130.00

They are in the South East of Melbourne

__________________
XE ESP The last of the CLEVO's
-----------------------------------------------------------

TTNOS8

Anyone used Performance Distributors?

Fat F100

Are "Performance Distributors" a brand, or company, or are you referring to Mallory, Accel & such ???????
As for Mallory & Accel, I was going to use one of these, but was told that you couldn't really get better than going to IC&E. I've had no problems with mine except a dodgy dizzy cap, & you can't blame them for that.

TTNOS8

No it's a company in melbourne.

xdc351

I have had 2 dizzys done through these guys and I am really impressed with their work.

One was for creating a mutant electronic dizzy with an old points dizzy and an XE electronic and recurving it for LPG, cost me $200 if I remember correctly.

__________________
Just like a Tsunami.

qwikcorty

for $120 u could buy the 2 kits from jaycar for ignitions. 1 is a hei, the other is a programable ignition computer with 2 sets of programs, each with rev limiter and electronic advance.

__________________
1976 351c td cortina

TTNOS8

Tell me more :)