daanp

I have seen somewhere info on the correct installation sequence for the inlet manifold on a 351C 4V. Can someone pls help!!
Thx, Daanp

CJR09

4V same, cheers

351cid

7 5 1 3 9
0---0---0---0---0
.........*-*
.........*-*
0---0---0---0---0
10 4 2 6 8

basicly work from the centre out.
i cant remember the touque settings.

i think that is the right amount of bolts.?

__________________
dave
`75 XB FAIRMONT SEDAN injected 351, toplaoder, disc brake 9", factory paint+ vinyl roof.
`03 BA XLS ute - lpg, auto, lsd, acid rush paint,
WWW.sunshield.biz

351cid

that is the picture i was trying to draw from memory. .

__________________
dave
`75 XB FAIRMONT SEDAN injected 351, toplaoder, disc brake 9", factory paint+ vinyl roof.
`03 BA XLS ute - lpg, auto, lsd, acid rush paint,
WWW.sunshield.biz

CJR09

lol - bugger that! I was gonna try but easier to take a coupla pics instead!

daanp

Thanks a lot for help.
Just a question on valve lifters. I have a bent/broken pushrod on #5 cyl. and must replace the lifter also but it wont come out. I thought it is just lifting it out and install a new one. It will lift in the sleeve but wont come out fully. Any suggestions how I can remove it?
Cheers

CLEVELAND JUNKY

Yes you can buy a lifter removing tool from a parts store. I dont know where you live but i bought mine from supercheap in Adelaide. The tool hooks into that slot on the inside of the lifter where the wire clip sits. I think you have to remove the wire clip first.

CLEVELAND JUNKY

Here is the tool i was talking about. Do a internet search on "Hydraulic lifter removal tool" for more info.

Attached Images

648459w.jpg (3.3 KB, 28 views)

daanp

Yes just the tool I was looking for. Will do search but think I have seen this tool in a store before.
Thanks for your help!
Cheers

brenx

I had a couple of stubourn lifters in the hyd cammed 351 that cam in my car. I found the cam had wiped lobes when I pulled that motor down.

__________________
XB Fairmont (street car) 11.07@123.02mph.