CRUSHU F150

just getting an expression of interest, for a set of engine mounts and brackets to make a 400m fit a falcon. they are well made brackets, that line up the c6 on the rear most set of holes on the rear cross member. the rubber mounts are new. i also have a big block c6, recently recoed and with shift kit, and tail shaft to suit a car. no good to me, as i need a 4x4 one. thanks

__________________
ford 79 f150 4wd, lifted 6", 15 x 10 alloys,38.5 x 14.5 swampers, 400ci supercharged, c6, np205, 9" and dana 44, side pipes, big stereo, step side body

clevo400

r these for sale or wanted ??? have u any pictures of them ???

__________________
regards
Stephen

CRUSHU F150

they will be for sale. the brackets look like standard brackets, flat plate, with box section over it, with anti crush tube where the bolt goes thru. the 4 mounting bolt holes have not been drilled yet, was going to do it in the car, for accuracy. they were made by DKR performance engines in adelaide. the mounts are new f series mounts. pics are not available, as my digi is getting fixed. thanks

__________________
ford 79 f150 4wd, lifted 6", 15 x 10 alloys,38.5 x 14.5 swampers, 400ci supercharged, c6, np205, 9" and dana 44, side pipes, big stereo, step side body