Ford Forums banner

Computer reset

3K views 0 replies 1 participant last post by  alex65 
#1 ·
Hope someone can help.
I did a water seal in my Vialle gas converter on a AU series 1.
Replaced the seal and ran ok for about 500ks then the gas solenoid on the tank shut and would not re-open.
I suspected a leak had develloped, so checked all conections on converter and disconnected battery to reset computer.
Everything ok for a while, now solenoid has dropped out again and computer will not reset.
(I have power to gas/petrol switch which then goes to computer- no power out of comp to activate solenoid. Have reassembled converter to be sure of no leaks)
Any ideas?
Thanks in advance
Alex
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top