fordfreak ef

How much RWKW gain will i get when i get my unichip installed??? + cam dialed in...
EF Fairmont I6 95
5 spd conver
Heavy duty clutch (daiken)
XR6 cyl head
Port job
Stage 2 crow cam..
Extractors..
2.5 inch
cold air intake..
at the moment 133.5 rwks... running rich.. not tuned..
Work to be done by Autotech Granville... 14.69 Q mile so far best...

__________________
163rwkw.. 14.4 @ 95.67mph.. EF 5spd 3.45 Lsd..

fordfreak ef

apparantly only was turning 120.00 rwkw due to the timing being right out badly... after the cam timing was corrected,the unichip installed,and then tuned on the dyno... it then ran 144.2rwkws...with the snorkel on!

A gain of 11.2rwkws.. The torque curve is so flat.. but strong torque jus off idle right through to redline..
No pinging now and no lag just off idle when not using revs to launch the car..
The car hammers now..just a constant surge of speed that doesnt slow down passing 150km/h in a flash from standstil... Feels like its got a rocket up its arse now!!! Thanks to spiro at granville AUTOTECH and the gang...
I highly reccommend their work to others....

__________________
163rwkw.. 14.4 @ 95.67mph.. EF 5spd 3.45 Lsd..

DOG20L

I've got similar mods to you in an EL XR6 except for the chip. How much did the chip and tune cost?

fordfreak ef

I got my type c unichip second hand off the fordmods forsale section for $560.00 inc postage.... i had to be patient cos they sell like hot cakes when put up for sale...
Was $500 for-
cam to be dialed in properly..
installation of the unichip..
dyno time programming the unichip..

If your doing the job with all new gear $1500+
nothing wrong with my second hand gear tho...
was worth every cent... its so faster its scary!!

__________________
163rwkw.. 14.4 @ 95.67mph.. EF 5spd 3.45 Lsd..