50LtCapri

Hi All,

Ok so I've just connected up all the wiring in the Capri.

At least we thought we had.

There is a sensor in each exhaust which I'm assuming are the O2 sensors. Now I would also assume that both of these need to be connected.

For the life of me I can only find a connection in the loom for one.

Is there something missing?

The loom is supposed to have been complete from a NF Fairlane. This is the way it was described to me when purchased.

TIA
Ross

__________________
New CAR July 2004 build BA XR8 Ute.
"It ain't got much show but it's got plenty of go"
Passenger quote after a ride in the XY 351 ute.
"Your going to put WHAT in there"
Engineers comment about the 5.0 Lt EFI transplant to the Capri.

Fairlane Boy

I've the wiring diagram for my nf v8 hear..

1 & 2 hego sensors both GY-Y wires on the sensors connect to the same place.. both BK-DG wires goto negative on the battery..
DG-DB wire from number one sensor goes to the ECU
DB-LG wire from number two sensor goes to ECU

cant realy make it any clearer, but if you still need help i can fax you a copy of the circut diagram

__________________
Best wishes

XR9UTE

Yes the harness you have is incomplete. They went to two halves from ED so yours is likely the same. So, the pricks(sorry but this happens on practically every conversion Ive done) probably only supplied half of it.

You can run without HEGO's but of course it'll never go into closed loop which will result in a slightly worse fuel consumption figure. No big deal really.

Pete.

50LtCapri

Thanks.

Ross

__________________
New CAR July 2004 build BA XR8 Ute.
"It ain't got much show but it's got plenty of go"
Passenger quote after a ride in the XY 351 ute.
"Your going to put WHAT in there"
Engineers comment about the 5.0 Lt EFI transplant to the Capri.