Ford Forums banner

MWM 4.2L TD Head Bolt torque setting

20K views 5 replies 5 participants last post by  Barry1185 
#1 ·
Hi

Just wondering if anyone would know the torque settings on a 2001 F250 4.2L MWM T/Diesel Inline 6 cylinder head bolts.

These engines weren't in the US market and were offered outside the US. This is an Australian F250 which is built in Brazil.

If anyone has any technical data on the torque settings on these engiines it would be much appreciated. I have tried google and have come up with absolutely nothing.

Thanks

Adam
 
#2 ·
Adam - have you found any results for your head bolt tesion. I know this is a bit late but here they are for a 6.07tca
If any bolts exceed 166.5mm they must be replaced
Install bolts & apply successive torques of 30Nm - 60Nm - 100Nm - 90 degrees - 90 degrees again
bolt sequence
13 9 5 1 3 7 11
14 10 6 2 4 8 12

I have the entire service manual from the importers who used to be in Brisbane if you require a copy

Roz:hy:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top