Dellboy999

Hi all,

Since I swapped my diff over and put in new shocks for the SLS, it has not functioned correctly, as I had the gearbox still to change I didnt worry abut it too much, but now the car is back on the road would be nice to have it working again.

I run the test as follows:

1. Start car
2. Press the drivers door switch to turn the interior light on and off 3 times within a second.
3. wait

The compressor runs shocks go up, then nothing, then I have 3 beeps repeated twice, and the check susspession light flashes 3 times as well at the same time, I think I may have even got 2 beeps this morning when I checked it again.

Can someone please post up what the codes mean, so I can begin to work on a resolution to the problem.

Jason

__________________

125

Dellboy999
Acoding to my book it is a
Height sensor fault.
Module senses some of its internal functions are not operating correctly.

Check that the lever off the height sensor has not been flicked over to the wrong side from memory its possible for this to happen

Dellboy999

that is a very good possibility 125, seeing as it was swinging free during the diff removal and install, will climb under the car and see what I can see ;0)

__________________

Dellboy999

'125' you were 100% spot on with the suggestion, I went home jacked the car up, and had a look, facing the back of the car, I had the control arm going to the left (passenger) side, and it should be to the right (driver) side, so once moved it is all happy and working fine, thanks again.

Jason

__________________