MR AUII

Where do i get wheel spacers from?
I have a set of rims that are the correct offset and stud pattern for my AUII but the center hole in the rims are not quite big enough to fit on the car. The rims go a little over but is only about 1-2mm bigger than the hole in the rim. Will wheel spacers allow me to use them? and where do i get them from?

__________________
2000 AUII Forte [RICEAU]
In Car Entertainer

INJECTED250

you would be better of, to take youre hubs of and get the sholder machined down 2 mm than running spacers...

__________________
EB FALCON
98 T5 gear box (was auto)
Wade 977b cam
3.7 lsd
AU bottem end
ELXR6 ported Head
PH4480 Pacemakers

Mike Gayner

Any engineering shop could machine either the hub or the wheel itself to correct size, I'm guess it would cost bugger all too.

MR AUII

might go see about getting the wheels machine. dont think you can do the hub because its very thin piece. I think its the bit that houses the bearing. when you take the cap off there is a nut in there.

__________________
2000 AUII Forte [RICEAU]
In Car Entertainer

012

What wheels are they? Photo?

Machining the center bore of the wheel 1-2mm will leave you with no center caps as the old ones will not fit, but depends on what the wheels are. BTW, spacers are illegal.

MR AUII

dont know how to post a pic without any webspace but check it out at this link.

http://www.caraudioaustralia.com/for...ttachmentid=35

__________________
2000 AUII Forte [RICEAU]
In Car Entertainer

RAPTOR

I don't know if you can access this AutoSpeed article without being a subscriber but it tells you everything you need to know;

http://www.autospeed.com/cms/A_2242/article.html

__________________

MR AUII

that may be absoloutely perfect for my application. Looks like i will be doing some running around after work tomorrow. Pretty fair priced too.

__________________
2000 AUII Forte [RICEAU]
In Car Entertainer