andrew143
I am new to the fourm, I have done it on my 90 tempo with out pulling engine. From underneth. First you must bend a boxend (i think 11/16 to fit the bolts on manifold)I also ground the top of it off so it would grab the bolts better. With the x-hast removed it should come out of there. I did it alone it takes a lot of swearing but you can do it. be carefull so you dont cut or damage the rubber boot on your axel shaft.The old one of mine came out in 3 pieces. Just take your time and you will figure it out.Did mine out in the cold norther minnesota eas like 20 above was not fun but it went.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ford Forums
1.4M posts
115.4K members
Since 1999
Ford Forum is a community to discuss all things Ford. Check out our discussions on the Ford Escape, Mustang, Edge, F-150, Raptor, Explorer, Focus, Fusion, Fiesta and more!