Ford Forums banner

96 blower motor resister location

1K views 1 reply 0 participants last post by  Gerald Riggs 
G
#1 ·
Would someone please direct me to the exact location of the blower
motor resistor on the 96 Explorer. Also any replacement
instructions.Thank you.
Paul
 
G
#2 ·
Sure, It is accessed from the engine compartment just below and inboard of
the blower motor. About 6-8 inches away. Held in by a couple screws. Tough
to get at so be patient. No particular instructions. There may be some
wiring to do since connector on replacement may be different. This is where
the one for my 96X was. My temp controller was an Automatic unit. Presume
same goes for a manual unit.
Jerry
<pmhoppe@juno.com> wrote in message
news:42bb4503.129727237@netnews.insightbb.com...
> Would someone please direct me to the exact location of the blower
> motor resistor on the 96 Explorer. Also any replacement
> instructions.Thank you.
> Paul
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top