|
Re: 4X4 lights flashing updated version
When you say you cleaned the metal sludge off the sensors, could you explain
this to me. I have been looking for a book on how to repplace the sensors
but cannot find anything local to purchase. Did you remove the sensors to
clean them if so how did you do this. Is this hard to do? I am mechanically
inclined. But I am just afraid to tackle this without prior knowledge. I
don't want to open the proverbeal can o worms. Will there be leakage in
changing the sensors? Do I need anything special?
The sensors cost 28 for one and 17 for the other, I am hoping that this is
all it is and the GEM and the shift motor is still good. Like I said before
the front wheels spin when the rear lose traction so I figure the TX case is
fine, I just don't hear anything to tell me that the shift motor is trying
to do the job.
I can remember when my 68 dodge charger tranny went and all it cost was 350
for another one and the fix was quick n easy.... Now just to figure out what
is wrong you need 1000 scan tools that give you a code that tells you whats
wrong. I know its much better now but whew that difficulties for the average
JOE are tremendous.
Searcher1
|
Linear Mode
