Re: Land Rover Radiator Blind
Tom Woods wrote:
> On 24 Nov 2005 11:21:57 -0800, "m0bcg" <firstname.lastname@example.org>
>>if you have a 300tdi landrover then cut a piece of ali plate 510mm x
>>the width is the 510mm side , put a 25mm 90deg bend on this so you can
>>slip the plate down in the gap between radiator and front scuttle plate
>>, ie just behind the bonnet catch .
> Has anybody got any good reasons why i shouldnt use a bit of cardboard
> wrapped up in duct tape and a binbag? (i'm feeling poor!)
None whatsoever .... but that's hard work. You could use anything
rigid, thin and (ideally) water resistant - hardboard, plastic sheet
.... all sorts of possibilities. Just look around the house, in a few
skips ... you'll soon find something suitable.