series 3 help please - Ford Forums - Mustang Forum, Ford Trucks, Ford Focus and Ford Cars
Ford Forum Ford Forum

» Auto Insurance
» Featured Product
» Wheel & Tire Center

Go Back   Ford Forums - Mustang Forum, Ford Trucks, Ford Focus and Ford Cars > Ford Cars and PAG Vehicles > PAG Vehicle Discussion > Land Rover
Register Home Forum Active Topics Photo Gallery Insurance Garage Mark Forums Read Auto EscrowAuto Loans

FordForums.com is the premier Ford Forum on the internet. Registered Users do not see the above ads.
Reply
 
LinkBack Thread Tools Display Modes
Old 03-21-2005, 01:16   #1 (permalink)
Alex Hill
Guest
 
Posts: n/a
series 3 help please

sereis 3 diesel
tried to start it up today
smell of burning coming from engine
had a look and engine stop cable had burnt through
and sparks around throttle linkage
any ideas?
thanks


  Reply With Quote
Sponsored Links
Advertisement
 
Old 03-21-2005, 01:16   #2 (permalink)
Dougal
Guest
 
Posts: n/a
Re: series 3 help please

Alex Hill wrote:
> sereis 3 diesel
> tried to start it up today
> smell of burning coming from engine
> had a look and engine stop cable had burnt through
> and sparks around throttle linkage
> any ideas?
> thanks


Failed earth connection between engine and chassis. It's using the stop
cable as a substitute.

It might be a simple case of dirty connections or the (usually) braided
cable earth has 'died'.

  Reply With Quote
Old 03-21-2005, 01:16   #3 (permalink)
JD
Guest
 
Posts: n/a
Re: series 3 help please

Alex Hill wrote:

> sereis 3 diesel
> tried to start it up today
> smell of burning coming from engine
> had a look and engine stop cable had burnt through
> and sparks around throttle linkage
> any ideas?
> thanks

Definite diagnosis -engine/chassis earth not working so starter current is
trying to go through the controls. Find the engine to chassis earth strap
and unbolt both ends and clean them, or alternatively run a new heavy earth
strap from chassis to engine or gearbox.
JD
  Reply With Quote
Old 03-21-2005, 01:16   #4 (permalink)
Alex Hill
Guest
 
Posts: n/a
Re: series 3 help please

thanks for your help
hope it sorts it!!
"JD" <jjd@SPAMLESS.com.au> wrote in message
news:4239d882@dnews.tpgi.com.au...
> Alex Hill wrote:
>
>> sereis 3 diesel
>> tried to start it up today
>> smell of burning coming from engine
>> had a look and engine stop cable had burnt through
>> and sparks around throttle linkage
>> any ideas?
>> thanks

> Definite diagnosis -engine/chassis earth not working so starter current is
> trying to go through the controls. Find the engine to chassis earth strap
> and unbolt both ends and clean them, or alternatively run a new heavy
> earth
> strap from chassis to engine or gearbox.
> JD



  Reply With Quote
Old 03-21-2005, 01:16   #5 (permalink)
Richard
Guest
 
Posts: n/a
Re: series 3 help please

Alex Hill wrote:
> sereis 3 diesel
> tried to start it up today
> smell of burning coming from engine
> had a look and engine stop cable had burnt through
> and sparks around throttle linkage
> any ideas?
> thanks
>
>



Similar near-disater happened to my first RRC. It had twin batteries
wired in parallel and Goodrich SS brake hoses (which is relevant!). The
clips securing the +ve strap from battery to starter solenoid broke
allowing the strap to become entangled with the steering column. After
a while the column wore through the insulation on the strap. Very odd
that at full LH lock the engine almost died and the lights dimmed.
Arriving at my destination I was surprised by the smell of burning
plastic. Rapid bonnet lifting revealed a surprising amount of smoke
followed by rapid battery disconnection, I retrieved the vehicle the
following day and found that part of the loom to the rear lights had
melted and the throttle cable had melted the plastic in the Bowden
cable. A large amount of new wiring, a bicycle brake cable as
replacement throttle and a pair of those instant battery disconnect
clamps from Vehicle Wiring Products saw the vehicle back on the road.

A few weeks later it was being tested for it's MOT when one of the
Goodrich hoses burst. We found that the plastic liners had melted in
all five hoses and concluded that they had offered a good-ish earth
return (but how?) during the wiring fault.

I mentioned it to Goodrich who were horrified and sent me a replacement
set. They said that they were going to include a warning to ensure that
earth straps in RR were carefully checked when fitting their hoses.


Rgds Richard


--
Real email address is RJSavage at BIGFOOT dot COM

The information contained in this post
may not be published in, or used by

http://www.diyprojects.info
  Reply With Quote
Old 03-21-2005, 01:16   #6 (permalink)
wayne@lardrover.co.uk
Guest
 
Posts: n/a
Re: series 3 help please

On Fri, 18 Mar 2005 06:20:41 +1100, JD <jjd@SPAMLESS.com.au> made me
spill my meths when he wrote:

>Definite diagnosis -engine/chassis earth not working so starter current is
>trying to go through the controls.


I've heard of speedo cables failing soon after similar mishaps as well
were the earth has chosen that route.
--

Wayne Davies, Harrogate 07989 556213

Just another point of view...
www.4x4prejudice.org
  Reply With Quote
Old 03-21-2005, 01:16   #7 (permalink)
DavidM
Guest
 
Posts: n/a
Re: series 3 help please

"Alex Hill" <ah012h2675@blueyonder.co.uk> wrote in message
news:6El_d.76963$ug2.43439@fe2.news.blueyonder.co.uk...
> thanks for your help
> hope it sorts it!!


You might want to take a look at a similar thread last week.
http://shortlink.co.uk/44f

From advide here it sounds as if my SIII also has a bad earth. The electrics
refuses to take any more current load than the charge and oil pressure
lights. Any more and it dies completely. I'll be checking all the earth
leads this Sunday to find out if they were right. The starter has been very
slow to turn recently and a feint hot/burnt smell has always come from the
engin bay after starting.

Good luck with your,
David

--
-------
# | |
:===[==¬|====;
[/ \|___|_/ \|
\_/ \_/
DavidM djm81NOSPAMatcam.ac.uk


  Reply With Quote
Sponsored Links
Advertisement
 
Reply

  Ford Forums - Mustang Forum, Ford Trucks, Ford Focus and Ford Cars > Ford Cars and PAG Vehicles > PAG Vehicle Discussion > Land Rover



Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Powered by vBadvanced CMPS v3.2.2

All times are GMT -7. The time now is 07:53.



Powered by vBulletin® Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.6.0
Garage Plus vBulletin Plugins by Drive Thru Online, Inc.