|
Re: Swivel pin housing oil level
"Richard" <richard.a.bush@googlemail.com> wrote in news:dl7a0u$ho2$1
@nwrdmz03.dmz.ncs.ea.ibs-infra.bt.com:
> I've been going over my landrover checking out all the oil
> levels. I'm a bit puzzled by the swivels. In my Haynes
> manual it shows a 'level plug' and a 'filler plug'. However
> I can only find a single square-section headed plug on
> either side of the vehicle.
>
> Got number two so to double check just in case I was missing
> the 'bleedin obvious'......He could also only find one.
>
> Anyway I topped them up through the one we could find.
>
> The vehicle is an ex-MOD 1986 90 - Do the military vehicles
> have different swivels on them?
>
> Just curios!
>
> Regards
>
> Richard
>
>
>
Some had one, some had two. Someone knowledgeable will be along in a minute
with dates and model numbers. I think mine has two on one side, one on the
other! Depends if they have been replaced or not, and with what!
BTW, someone said to fill them up to the top. Others to the levelling plug
(if it has one). To the top is probably safer. I prefer oil (EP90) rather
than one shot grease as it's easier to deal with if I have to adjust the
swivel pre-load. The grease is designed to get everywhere, and it does.
Derry
|
Linear Mode
