Hey Guys, This one is a little puzzling..... I own a 2006 Crown Victoria LX My mechanic neighbor replaced my rear axle with a police axle (had no choice, a new one would have been a ton of money in California) and it threw the speedo way off because of the change in ratios. I'm now a little...

Hi i have problem with just the high beam not working the I check the bulb its good I expect the problem to be one of these two 1-high beam switch(turn signal) 2-LCM How do I make sure which one make the problem

I was looking at buying a 1972 Ford mustang with a 351, but it's got an issue where the throttle cuts out when you give it too much power. Apparently the issue is new, as it wasn't a problem until the guy replaced his carburetor and intake manifold. I don't know much about carbureted engines...

Hello my truck wouldn't start and battery and alternator all checked out to be ok and was able to jump truck off at starter solenoid. Replaced solenoid with aftermarket O'Reilly's brand and truck drove fine for a couple of weeks and then started doing it again and was able to jump off again at...

it started 4-5 days ago if I didn't hold the ignition on for at least 2-3 seconds it would act like it is flooded but after waiting a few seconds it would start but now it just turn over and over and over and will not start