Ford Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
So I found my 97 ranger 4cyl 2.5 manual not starting one morning and found no spark past coils and since it was due for a tune up any way

I went and replaced the plugs, wires and ignition coils

It cranks just fine and the timeing belt looks solid

I tested for voltage at the coils and it reads just fine but I still get no spark

Im a novice when it comes to engines but can follow directions so anyadvice is welcome

I have codes but dont think they affect starting the engine but here they are: P0401 "egr", P0135 "O2 sensor", P0401 "exaust pressure low"
 
1 - 3 of 3 Posts
Top