Ford Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
HI, My Freestar was purchased by a private school as a run around vehicle , until I got it in 2014 with 115k and a rebuilt trans. Now she has 170k and I used her to deliver catering until Covid killed the business and have changed the trans fluid / filter by dropping the pan twice since I got it . When trans is hot ( whether after exiting interstate or after 30 min stop and go city traffic) It holds in 1st gear until 3000 rpm or just over before hard shifting into 2nd. 2-3 shift is fine as is 3-4. Once she cools down she shift as she always had .
Tonight was the first time i saw what I assume was the check engine light ( seriously, she is a good van) flashing . It was a gear with a exclamation point in the middle on the lower left corner of the dash. But it was off upon next crank and I can't find my scanner. Any help is appreciated. Thanks
 

·
Super Moderator
Joined
·
21,779 Posts
You really need to find your scanner and check for stored fault codes .
 
1 - 4 of 4 Posts
Top