[SteveBobo]

Hi,

Well, it seems I have a blown out head gasket. The coolant system is pressuring up and the engine is overheating. The Original problem was a leaking water pump. After replacing the water pump and then the radiator we are still pressuring up and overheating. I have de-gassed the system several times. I have considerable mechanical experience, but have never pulled a head. I'm leaning towards doing the job if I can find the detailed job break down. Can some one help me with this please.

Many thanks,

Steve

 

[R.S.LOGAN]

Take it the thermostat is not jammed and the rad fan cutting on o.k ? If so , this is a walkthrough by one of our former members for a Ford Taurus 3.0L 12v . A block test usually confirms heads / gaskets gone or not .May be similar to your vehicle but not sure . Might / might not help.

 

[SteveBobo]

Thanks R.S,

I think the thermostat, radiator and fan are in order. That video is for the Vulcan engine, not the duratec that I have. I wonder if there is a similar video or written instructions for the duratec.

Any help to find what I need for the duratec would be greatly appreciated.

Steve

 

[R.S.LOGAN]

Seem there is a lack of videos for the Duratec but if I can find any walkthroughs or videos I will stick them up here .

 

[R.S.LOGAN]

Only info I can find that might be of help refers to a 03 ford escape 3.0 liter dual overhead cam . Major job and you would be advised to get heads pressure tested also in case of cracks .

https://www.justanswer.com/ford/71ckz-head-gasket-replacement-03-ford-escape-3-0-liter-dual-overhead.html