Ford Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
i have a 1959 292 and was wondering if the tranny and bell housing from my 1953 cost clipper 6 cyl engine will bolt up and work?
 

·
Registered
Joined
·
84 Posts
Hi, Why? If both transmissions are cast iron FordOMatics, you might be able to swap the main trans, but use your 292 bell housing and torque converter. Spline must match. If you have the aluminum 2 speed, I would say no.
 
1 - 3 of 3 Posts
About this Discussion
2 Replies
2 Participants
ROBERTSUNRUS
Ford Forums
Ford Forum is a community to discuss all things Ford. Check out our discussions on the Ford Escape, Mustang, Edge, F-150, Raptor, Explorer, Focus, Fusion, Fiesta and more!
Full Forum Listing
Top