Ford Forums banner

1 - 3 of 3 Posts

·
Vintage Mustang Member
Joined
·
19 Posts
Discussion Starter #1
Well we trial fitted the new 347 stroker in the 65 FB last Friday. Headers were a tight fit, but went in after adding a 1/4 inch spacer to raise the motor up a bit. So the headers are back out and on the way to be Jet Hot Coated along with the new exhaust set-up. Can't wait to get this thing back on the track. Its been a while since the old 306 finally gave up. We had the motor on the engine Dyno for 2 days last weekend, so I think we have the tuning figured out.

Ron
 

·
PT Owner - SCPOC Prez
Joined
·
681 Posts
good job! :thumbup:

keep us updated and post some pics of the engine and the car its going into! ;)
 

·
Vintage Mustang Member
Joined
·
19 Posts
Discussion Starter #3
Should have some photos in a couple of weeks. I do have a shot from last year... The motor Dyno'd at 604.6 HP at 7400 and 487 ft/lbs of torque at 5400-5800, so it should run a bit stronger than last year. Can't wait to get her on the track.

Ron

 
1 - 3 of 3 Posts
Top