Ford Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
New to the board.

My brother is rebuilding a 67 Falcon Futura Sport Coupe and the floor pans are all rotted out. He has a donor car but thus the same, all rotted out on that too. He has tried to find some through various vendors but has not found any. My questions to you are; Is there a place that sells these floor pans or is there a place that has a blueprint of them so he can have them made? Any help would be greatly appreciated.

Thanks.
 

·
Registered
Joined
·
221 Posts
Islair said:
My brother is rebuilding a 67 Falcon Futura Sport Coupe and the floor pans are all rotted out. He has a donor car but thus the same, all rotted out on that too. He has tried to find some through various vendors but has not found any. My questions to you are; Is there a place that sells these floor pans or is there a place that has a blueprint of them so he can have them made?
I don't know of any made in the US. BUT, there used to be a web site that was run by a Falocn owner who used a set of reproduction Mustang floor pans to repair his 65 Falcon. I tried to go to the site a few months ago and it is no longer active. The 66-70 Falcons share a lot with the 66-67 Fairlanes and 67-68 Mustangs. I'd bet a set for a 67-68 Mustang could be sectioned in.
 

·
Registered
Joined
·
26 Posts
Islair said:
New to the board.

My brother is rebuilding a 67 Falcon Futura Sport Coupe and the floor pans are all rotted out. He has a donor car but thus the same, all rotted out on that too. He has tried to find some through various vendors but has not found any. My questions to you are; Is there a place that sells these floor pans or is there a place that has a blueprint of them so he can have them made? Any help would be greatly appreciated.

Thanks.
same as the humble xr falcon mate as long as they are the front sections. if its the rear im affraid your going to have to make em by hand.
 

·
Registered
Joined
·
15 Posts
Islair said:
New to the board.

My brother is rebuilding a 67 Falcon Futura Sport Coupe and the floor pans are all rotted out. He has a donor car but thus the same, all rotted out on that too. He has tried to find some through various vendors but has not found any. My questions to you are; Is there a place that sells these floor pans or is there a place that has a blueprint of them so he can have them made? Any help would be greatly appreciated.

Thanks.

Check Ebay Motors , you'll find them reproduction pressed & ready to go & they . Other than that contact Dearborn Classics & they should be able to put you onto someone that can supply them .

Cheers

PV
 
1 - 6 of 6 Posts
Top