Ford Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
I have a E0AE 302 block has anyone bored one of these .040 over. Is there A site I can go to thst might have a chart I can look at.


thanks AJ
 

·
Super Moderator
Joined
·
1,188 Posts
You can bore it as big as you can get pistons for it. Read 302lifter's post. Anything over
30 is fine as long as you are only using your car to go to 7/11 for coffee. drag strip
or street race i'd think again. that block is pretty thin.
 
1 - 3 of 3 Posts
About this Discussion
2 Replies
3 Participants
chipset
Ford Forums
Ford Forum is a community to discuss all things Ford. Check out our discussions on the Ford Escape, Mustang, Edge, F-150, Raptor, Explorer, Focus, Fusion, Fiesta and more!
Full Forum Listing
Top