Ford Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey guys just wondering if it's possible to get holes fixed, caused by bent push rods in a 250 X flow?
 

·
Super Moderator
Joined
·
9,505 Posts
There are those that will say yes as long as the holes are very minor. Typically, the wholes I've seen rods do, it's highly unlikely. You're better off getting a used block and rebuild it.
In my opinion, whether it's holes or cracks, the structural integrity of the block is gone.
 
1 - 2 of 2 Posts
Top