Ford Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
7,750 Posts
I must have missed that one. It is a nice looking unit do you know of anyone who has tried it and of their opinion?

BTW Strife my eyesight aint what it used to be. What is the obstruction blocking the front portion of the picture in your avator
 

·
T5 Expert Operator
Joined
·
6,542 Posts
Wonder if they make it for the IL6 :confused: :confused: :confused:

I'm abit wierry to drill holes etc my self in the car.
 

·
Registered
Joined
·
7,750 Posts
At the first meeting of the Tas Xr owners club, I noticed one of the guys had cut a 3" hole in the side of the air box and attached a section of hose out to behind the grill as well as the original air intake. Another guy had replaced his air intake with the one off the T series.

I have also noticed in Motor Mag an add for SS inductions that have a new air in take for the AU as well. Of the methods above the one strife has posted certainly looks the job. I wonder what the falcon one would look like if they even make one for it that is!
Afterall they did say popular:( :eek:
 

·
The Third Power
Joined
·
1,332 Posts
Discussion Starter #5
I used to have one in the grange till I got over the bolt on mods :nuts: it was better than the HSV cold air induction.

They back page reads Induction Unit to suit Ford EF - AU 6 cyl and 8 cyl and Fored AU XR6 and XR8

HSE2 dam if you were younger you would pick it from a mile away
:wink2: better viewing www.grungy-grange.com

The kit for the LS1 was made to use factory holes so I dont doubt that the fords would be the same. I think you need to watch a few tim the tool man videos ;)
 
1 - 6 of 6 Posts
About this Discussion
5 Replies
3 Participants
HSE2
Ford Forums
Ford Forum is a community to discuss all things Ford. Check out our discussions on the Ford Escape, Mustang, Edge, F-150, Raptor, Explorer, Focus, Fusion, Fiesta and more!
Full Forum Listing
Top