Ford Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
hi every one , here one for yer , I'm currently fitting a 383 Chevy into a EA falcon. wanted to do some thing different to every one else. have also changed the front end to xr8 clip. here some photo's.



 

·
Registered
Joined
·
5 Posts
Discussion Starter #4
so far looking pretty good , need to make some changes , like will need small base dizzy , make a bracket for the power steering pump. will fit a low mount alt. Have to make a cross member for the 350 turbo and then look at the drive shaft.
 

·
Registered
Joined
·
39 Posts
yes my buddy plays with these 383 chevs all the time...

about 500hp is the upper limit for the sbc as over 550hp and you start to snap crankshafts! or need expensive billet items that cost more than the engine and car itself.

i did know of a guy who was going to stick a 340 chrysler small block into a EA. but the project never got off the ground. he had the car and the engine but never connected the dots.
 
1 - 8 of 8 Posts
About this Discussion
7 Replies
4 Participants
Je_1st_Potatoe
Ford Forums
Ford Forum is a community to discuss all things Ford. Check out our discussions on the Ford Escape, Mustang, Edge, F-150, Raptor, Explorer, Focus, Fusion, Fiesta and more!
Full Forum Listing
Top