F
FastProbeSE
·Guest
Joined
·
0 Posts
sorry boys you have to click on my web site.....
a lot of good pics though..........
a lot of good pics though..........
My 96 PSE ATX
Join the discussion
Recommended Reading
-
91 lx no fuel pressure
Ford Probe Forum | Mazda MX6 ForumHi all. Got a 91 3.0 lx probe. Got injector pulse and spark but no fuel pressure. New pump,inertia switch and still just can’t get pressure on pump to turn on. Any help would be greatly appreciated- 4
- 174
-
Sloppy tranny
Ford Probe Forum | Mazda MX6 ForumLooking for shifter bushings for 89 gt does anyone know if they are the same as the Mazda 626 turbo? Seems to be harder and to find parts nowadays... TIA.- 4
- 201
-
1995 Probe GT Oxygen Sensor Connector Missing
Ford Probe Forum | Mazda MX6 ForumI recently went to get the car I just bought smoged. It failed. Running to rich. Engine codes for O2 sensors. I changed the two out that are accessible from the hood. On top of each exhaust manifold. Now I’m working on the one just past the catalytic converter. I removed it only to find out it...- 2
- 170
-
JonDom · updated
-
94 probe cold air leaking through upper vents while running the heat
Ford Probe Forum | Mazda MX6 ForumI have blocked off the hvac inlet under the cowl grill as a test assuming the air was leaking in there, but no change. Floor vents have good warm air coming out, can't find any diagrams to get any further ideas where this might be coming from. Any thoughts?- 10
- 347
-
Graystang88 · updated
-
Ford probe water drain holes
Ford Probe Forum | Mazda MX6 ForumHi, everyone Sorry to bother again, can you point out were the door drain holes are located on ford probe ? I'll draw a red circle on picture 😅until so i can figure out the spot.- 5
- 263
-
jonPS · updated
Join now to ask and comment!