Joined
·
18 Posts
New Update for the V6 event
Join the discussion
Recommended Reading
-
Probe crank sensor pinout
V6 and Hot4 TechHi, I'm looking for schematic or pinout diagram for this sensor (to be used with Megasquirt) https://www.amazon.com/Brand-Crankshaft-Position-Sensor-1992-1997/dp/B00FSC41GY It seems to be bit hard to find proper information.- 1
- 1K
-
4.0L SOHC Heads.
V6 and Hot4 TechHello everyone. I was wondering, are the 4.0L SOHC heads aluminum or cast-iron? I'd like to get one for a build I'm doing but just thought I would find out before hand. Thanks for your time- 2
- 616
-
oil leak 3.5L
V6 and Hot4 TechHello, Vehicle is a 2010 Ford Taurus 3.5L. There's been puddles of oil under the car and I can't find the leak. The dealer couldn't find it either. The other day I was under the hood doing something and noticed oil inside the lip of the part pictured. Part is located on the valve cover closest...- 3
- 1K
-
Another 2.5L Pinging engine
V6 and Hot4 TechAnother 2.5L Pinging engine I have a 99 ford ranger 2.5L with 95k miles that pings, it doesn't matter if its cold or hot. I have dealt and researched this problem for over two years and have just about given up. She runs great since i replaced all these parts however the ping is always there...- 10
- 913
-
High idle
V6 and Hot4 TechI have a 1995 Mystique V6 with a 3000 rpm idle. I have replaced all sensors, rewired and insulated all wires I could see, replaced IACV and tried two remanufactured ECMs. The IACV gets a continuous 12v. I have put some resistance in the line to bring the idle down to 1100, however this is not...- 2
- 555
Join now to ask and comment!