Ford Forums banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Just received an Innovative Motorsports MTX Digital Oil Pressure and Temperature gauge to install on a 289. The Oil Temperature sensor has a 1/4" NPT pipe thread and the sensor is about 1 inch long past the threads. Any ideas where to best place the sensor? I was thinking of drilling and tapping the oil drain pan plug but I would prefer to keep the sensor and wiring up on the block if possible.
Thanks Mitch
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.