Ford Forums banner
1 - 1 of 1 Posts
G

·
Discussion Starter · #1 ·
Re: Turbo seal

if you are realy not sure then just start the engine after normal
precautions then have a fire extinguisher handy, if the engine starts to
runaway then just dump the contents of the extinguisher into the inlet
manifold. But to be honest if it were going to leak that much I suspect it
would be only too visible before fitting.
"Steve" <[email protected]> wrote in message
news:[email protected]
> Dougal wrote:
>
>> There was another thread entitled 'turbo priming' here last week.

>
> That was mine too, before I found the oil in the air outlet side. Now I
> wonder if the engine ran away at some point.
>
> Steve
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top