Ford Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,023 Posts
If im not mistaken this is the re-enforcement plate for the area where the clutch cable goes through the firewall.
I had to install one of these on an EA when I was a Mechanic, and its welded on the front of the firewall(engine side), all that has to be done is to remove the insulation around the area and pull back the carpet under the pedals. Make sure you have wet towels around the pedals to prevent against any welding sparks igniting the carpet.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top