Ford Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I recently pulled the blown online 6 out of my F150 and am attempting to put in a 351 Windsor but am having troubles. Do I need special motor mounts or what needs to be done for this application.
 

·
Super Moderator
Joined
·
7,646 Posts
What year truck? The motor mounts for the 6 will not fit the 8, you will need to get different ones. I'm not 100% sure, but I think you might need a different bell housing as well. The last time I did a swap like that, it was with a Dodge and there were bolt holes for the different configurations, I just had to figure out where to put it all.
 
1 - 2 of 2 Posts
About this Discussion
1 Reply
2 Participants
CatSkinner
Ford Forums
Ford Forum is a community to discuss all things Ford. Check out our discussions on the Ford Escape, Mustang, Edge, F-150, Raptor, Explorer, Focus, Fusion, Fiesta and more!
Full Forum Listing
Top