[george 351]

These

or these

The two on the left are blue thunder,not sure if you can run girdles though,and the one on the right is Garret Machine.

Opinions welcome

 

[nhanst]

Go with the billet looking ones..much better looking..! :hy:

 

[xdclevo]

The two on the left are blue thunder,not sure if you can run girdles though,

The ones on the left look like the ones davis runs, so would assume a stud girdle would be fine under them. They both look good :hy:

 

[351cid]

i like the blue thunder ones better i think but they would both look tuff.

 

[tony xa]

I like the 3rd pic just because they look like bussiness and I have always liked the prostreet engine bay look

 

[ch7472]

These

or these

The two on the left are blue thunder,not sure if you can run girdles though,and the one on the right is Garret Machine.

Opinions welcome

Where do you get the Garret ones from. And how much??

 

[george 351]

Where do you get the Garret ones from. And how much??

They are US$189 and are made by Garrett Machine in the states.Basically the same shape as the Moroso ones but cast alloy.The blue thunder ones are around US$270.I've been told you need to run spacers with these to fit girdles but not 100% sure.Maybe Davis can enlighten me.

 

[davis]

They are US$189 and are made by Garrett Machine in the states.Basically the same shape as the Moroso ones but cast alloy.The blue thunder ones are around US$270.I've been told you need to run spacers with these to fit girdles but not 100% sure.Maybe Davis can enlighten me.

Spacers are definitely NOT required...there is a bunch of room inside of them.

...shows that you have a lot of room inside of them.

...another shot of them.

This will give you an idea of how much space the girdles require. There is at least an inch more space inside of the valve covers.


:davis: